Guntermann & Drunck DVIMUX4-DL-USB - Handbuch (Seite 57)

Switching
G&D DVIMUX4-DL-USB · 11
English
Enabling the »Switch« mode
If necessary, change the standard mode (see page 27) of the Service port to this mode if
you want to switch channels via the serial device immediately after starting the KVM
switch.
An alternative to switching to the Switch mode is to enter the » ! « command during
operation.
Switching commands
The following commands are provided for switching the channel:
Messages
The KVM switch confirms the successful execution of a command and otherwise
sends a meassage.
IMPORTANT: The Service port of the KVM switch can be used to operate the setup
menu as well as to switch between the channels with a serial device.
Switching of channels via the serial device is possible only if the
Switch mode is active!
Command Channel
1! 1
2! 2
3! 3
4! 4
<! switch to previous channel
>! switch to next channel
ADVICE: Use the » ?! « command to show the currently accessing channel.
NOTE: The serial device carries out the command directly after it is sent.
A message (see below) informs the serial device concerning the success or failure
of the switching of channels.
Message Meaning
In [x] All switching to channel [x] successful
E01 invalid channel number (out of range)
E06 channel switching failed
E10 invalid command
E13 invalid value (out of range)
RS232 mode enabled switch mode (RS232) enabled