Hach-Lange TENSETTE plus User Manual - Handbuch (Seite 34)

Maintenance
34
6.3 Sterilization
The tip cone module can be sterilized by autoclaving it at 121 °C
(250 °F) for 20 minutes. You can use steam sterilization bags if
needed. Disassemble and reassemble the tip cone module according
Section 6 Maintenance on page 31 .
After autoclaving the module must be cooled to room temperature for
at least two hours. Before pipetting, make sure that the module is dry.
We recommend that you check the calibration after every sterilization
cycle.