WIKA CPH6400 - Handbuch (Seite 27)

27 WIKA operating instructions, model CPH6400
11313439.04 12/2012 GB/D
GB
6. Commissioning, operation
6.4.4 Info screen
Via the MODE key different functions can be superimposed, e.g. the function: Info (INFO).
Activation of the Info screen
Pressing the MODE key four times* (directly within the standard measuring mode)
* If you are in a different measuring mode than the standard measuring mode, press the MODE key until the
measuring mode with the Info Screen function appears on the display).
1) Serial number of the CPH6400
2) Current Firmware version in the instrument
3) Internal sensor number of the currently-connected sensor
4) Pressure type for the currently-connected sensor
5) Accuracy in % FS of the currently-connected sensor
6) Lower limit of the measuring range for the currently-connected sensor
7) Upper limit of the measuring range for the currently-connected sensor
8) Calibration date of the currently-connected sensor
MODE
Return to the standard measuring mode by pressing the MODE key several
times.
6.5 Pressure units
Via the UNIT key, depending on the measuring range of the current pressure sensor, the
units bar, mbar, kPa, psi, mmHg, inHg or kg/cm² can be selected.
Press the UNIT key until the required unit is displayed (ring-shift).
6.6 Measurement signal processing
The standard value for the filter for the measuring signal processing/smoothing is a factor
of "3" and can only be altered, to a value between 1 and 5, using the WIKA "PrintCal" PC
software.
1 = no filter, ... , 5 = high filter
Info screen
1
3
5
7
2
4
6
8