Gb 6. commissioning, operation – WIKA CPH6400 Benutzerhandbuch
Seite 28
28
WIKA operating instructions, model CPH6400
11313439.04 12/2012 GB/D
GB
6. Commissioning, operation
6.7 TARE function
In the measuring mode you can carry out a zero point correction on overpressure sensors
via the TARE function.
Activating the TARE function
Pressing the TARE key. This sets the current display to 0 and from then on all measure-
ments are displayed in relation to the set TARE value. The legend TARE, displayed
directly above the pressure unit, indicates that this function is active. Press the TARE key
again to deactivate the TARE function.
1. Battery level display
2. Indication that the TARE function is active
3. Current pressure measured value
4. Current unit and type of pressure
5. Bar graph
6.8 The function key, "FUNC"
6.8.1 Backlighting (LIGHT)
Via the FUNC key various configurations can be achieved, e.g. the backlighting can be
switched on and off.
Activation of the backlighting (LIGHT) menu item
Pressing the FUNC key once* (directly within the measuring mode).
* If you already are in a FUNC menu item, press the FUNC key until the "LIGHT" menu item appears.
Activated TARE function
1
3
2
4
5