Lenze Cam Designer Professional getting started - Handbuch (Seite 47)

Cam Designer Professional
L
45 Cam Designer Professional DE/EN 2.0
2 System requirements
The following hardware and software requirements must be met in order to use Cam Designer
Professional:
• Microsoft Windows 98 / ME / NT (service package 5.0) / 2000 (service package 2) / XP
• 32 MByte RAM
128 MByte RAM (XP, 2000)
• IBM-compatible PC (CPU: Pentium 90 processor or higher)
• Super-VGA screen
• Hard disk with a minimum of 70 MByte of free hard disk capacity
• CD-ROM drive
• Microsoft-compatible mouse
• Parallel port for dongle connection
• Global Drive Control V4.0 or higher (32-bit version)
3 Installation
3.1 Installation of the dongle
The dongle, which is included in the delivery package of the Cam Designer software, is required to
ensure proper operation of Cam Designer Professional.
Connect the dongle to any parallel port (LPT1, LPT2, ...) of your PC and tighten the screws at the port.
• If the port is already used by a printer, it is possible to connect the printer to the dongle.
• If there is not enough space available, an extension cable can be used to connect the dongle.
For this, use a standard cable with a DB-25 male plug and a DB-25 female plug.
Demo version
The dongle is not required for the demo version of the Cam Designer software. The demo version is
restricted as follows:
• The program can only be used for a limited period of time.
• It is not possible to save projects.
3.2 Software installation
Proceed as follows to install the Cam Designer software on your PC:
1. Start Windows.
2. Insert the “Cam Designer” CD-ROM into your CD-ROM drive.
3. Select
Run... from the start menu.
4. Enter the letter for your CD-ROM drive followed by “ :\setup.exe” in the command line and
press Ok.
5. Follow the instructions of the installation program.
Show/Hide Bookmarks