Use / troubleshooting, Changing the batteries, Troubleshooting – Powerfix Z30225 Benutzerhandbuch
Seite 15
13
GB/IE
Use / Troubleshooting
Move the On / Off switch
9
into position “ON” to
switch on the LEDs
20
.
Note: The LED bulbs
20
are non-replaceable.
Point the precision engineer’s LED magnifying glass
1
with the LED lamps
20
at the clamped work piece.
Release the alligator clips
18
in order to remove the
work piece.
Move the On / Off switch
9
into position “OFF” to
switch off the LEDs
20
.
Changing the Batteries
Pull the battery compartment cover
3
in the direction of
the arrow to remove it from the battery compartment
4
.
Take out the old batteries.
Place the new batteries
21
of type 1.5 V , AAA into
the battery compartment
4
.
Note: Ensure the correct polarity. This is shown in the
battery compartment
4
.
Push the battery compartment cover
3
back in the
opposite direction to the arrow in order to close the battery
compartment
4
.
Q
Troubleshooting
= Problem
= Cause
= Solution
66454_pow_Feinmechaniker_LED_Lupe_content_LB3.indd 13
25.05.11 17:35