EUCHNER HBAS 094594 - Handbuch (Seite 53)

EUCHNER Hand-Held Pendant Station HBAS-094594
095640-02-02/06 Subject to technical modifications Page 13 / 40
5. Behavior on switch on / initialization
Immediately after the power supply is switched on, the HBAS is in an initial passive state.
The hand-held pendant station performs a self-test; this takes approx. 7 seconds.
After the self-test, a short sound is emitted and for 5 seconds it is possible to open the
Configuration (Konfiguration) menu using the <ENTER> key. The serial communication
interface is activated when this period has elapsed.
The EUCHNER LOGO is shown on the display and initialization by the control system
is awaited.
Until the initialization (see section 9) has been performed, all key operations are ignored.
5.1 Configuration (Konfiguration) menu
On the Configuration (Konfiguration) menu all parameters, that enable the hand-held
pendant station to be configured to meet specific requirements, can be changed manually.
It takes approx. 5 seconds to save a parameter change. The successful application of the
new parameters is confirmed by a short sound.
The Configuration (Konfiguration) menu is protected with a PIN. (Default setting on delivery
"1234").
The serial communication interface is shut down.
After the power supply is switched on, the text "Configure hand-held pendant station,
<ENTER>“ (Handbediengerät konfigurieren, <ENTER>) appears after the self-test.
The user now has 5 seconds to open the menu using the <ENTER> key.
After <ENTER> is pressed, a prompt for the PIN is displayed. A PIN with a maximum of
4 digits is to be entered. The exception here is the SuperPIN (151050) with 6 digits; this
PIN cannot be changed. It is possible to delete a character using the key.
The following settings are now possible:
Change PIN (PIN ändern) (section 5.1.1)
Priority (Priorität) (section 5.1.2)
Version information (Versionsabfrage) (section 5.1.3)
Pulse generator (Impulsgeber) (section 5.1.4)
Key click (Tasten-Klick) (section 5.1.5)
Firmware Update (section 5.1.6)
A selection is made using the keys, the selection is confirmed using <ENTER>.
The Configuration (Konfiguration) menu is left using the <ESC> key.
KONFIGURATION: KONFIGURATION: KONFIGURATION: KONFIGURATION:
Pin ändern Pin ändern Pin ändern Pin ändern
Priorität Priorität Priorität Priorität