EUCHNER HBAS 094594 - Handbuch (Seite 58)

EUCHNER Hand-Held Pendant Station HBAS-094594
095640-02-02/06 Subject to technical modifications Page 18 / 40
5. When the command word has been correctly received,
the HBAS switches to the send mode
(text "Ready for data transfer" (“Bereit zur...“) is displayed).
The Status LED goes out.
The data transfer can be started.
Warning:
When the hand-held pendant station is in the send mode,
a data transfer must take place. Then the hand-held
pendant station is reset to the normal mode.
If a transfer does not take place, this state can only
be rectified by Euchner.
5.2 Setting the baud rate
The hand-held pendant station automatically detects the baud rate of the control system
and sets itself accordingly. Possible values are 9600 and 19200 baud.
This automatic setting is made on the initialization of the hand-held pendant station
(see section 9). A change to the baud rate can only be made when the hand-held pendant
station is briefly isolated from the power supply. On the subsequent re-initialization the
HBAS is set to the new baud rate.
5a.
Change Baud Rate
to 57600
5b.
Click "Start" button
The data transfer takes
approx. 45 seconds.
(20 sec. for flash clearing
and 25 sec. for flash
programming)
Then the HBA
commences initialization.
Firmware Update Firmware Update Firmware Update Firmware Update
Bereit zur Bereit zur Bereit zur Bereit zur
Datenübertragung
Datenübertragung Datenübertragung Datenübertragung