Festo Генератор вакуума OVEM, дюймовый - Handbuch (Seite 83)

OVEM
Festo ć OVEM ć 1004b English 83
6.2 SHOW mode
The SHOW mode shows the following settings and values:
Settings for Out A/B
Ĉ Switching function [threshold/window comparator]
Ĉ Switching points [SP], switching point [SP] with LS−active or [SP] [min] and [SP] [max]
Ĉ Hysteresis [HY], hysteresis [HY] with LS−active
Ĉ Switching characteristic [NO/NC]
Extreme values of In A
Ĉ Minimum pressure value [min]
Ĉ Maximum pressure value [max]
Reject pulse length of In B
Ĉ Duration of reject pulse in [msec]
Diagnosis (A button + B button = C button)
Ĉ Permitted evacuation time [msec]
Ĉ Permitted pressurization time [msec]
Ĉ Evacuation time [min]āā[msec]
Ĉ Evacuation time [max]āā[msec]
Ĉ Pressurization time [min]āā[msec]
Ĉ Pressurization time [max]āā[msec]
6.2.1 Display settings for Out A/B
The vacuum generator need not be in the RUN mode.
· Press the A button (switch output Out A) or B button (switch output Out B).
è The SHOW mode of the relevant switch ouput is active.
Note
If there are faults, appropriate fault numbers will first be displayed when the A or B
button is pressed (è chapter 8.2. Diagnosis).
· Press the button of the selected switch ouput again.
è If you continue pressing the same button, the current settings of the relevant switch output will
be displayed one after the other.
When all the values have been shown and the button is pressed again, the RUN mode will
become active again.