WIKA TIF52 - Handbuch (Seite 15)

WIKA operating instructions models TIF50, TIF52 15
GB
14009686.02 03/2012 GB/D
This monitoring only generates a signal if two valid sensor values can be determined and
the temperature difference is higher than the selected limit value. (Cannot be selected for
the 'Difference' sensor function, since the output signal already indicates the difference
value).
6.2.1 Configuration via the PC
To configure the transmitter, both configuration software and a HART ® modem are needed.
WIKA offers 3 different models of HART ® modem for this.

HART ® modem with USB interface, model 010031,
Order no. 11025166

HART ® modem with RS-232 interface, model 010001,
Order no. 7957522

Bluetooth HART ® modem, ATEX, CSA, FM approved, model 010041
Order no. 11364254
The HART ® modem can be used together with the mentioned configuration
software (see below "Configuration software WIKA_T32").



Configuration software WIKA_T32
The use of the WIKA_T32 configuration software is recommended. This is constant-
ly updated and adapted to T32 firmware enhancements. Thus full access to all the
transmitter‘s functionality and parameters is always ensured.
Further configuration software
With the following software tools it is also possible to carry out configurations at the T32 e.g.:
■ AMS and SIMATIC PDM (T32_EDD)
■ FieldMate, PACTware, SmartVision and Fieldcare (DTM_T32)
■ DTM in FDT 1.2 frame application
With any other HART ® configuration tool the generic mode functionalities can be operated
(e.g. measuring range or TAG no.).
Further information on the configuration of the T32 with the software tools menti-
oned above is available on request.
6. Commissioning, operation