WIKA TIF52 - Handbuch (Seite 31)

WIKA operating instructions models TIF50, TIF52 31
GB
14009686.02 03/2012 GB/D
The following table shows the error codes and information regarding the failure cause and
elimination.
Error code Description Causes
1 Transmitter does not respond
2 Communication error ■ Parity, check sum, package length incorrect upon
receiving
■ Transmitter signals receive error
3 Command not implemented Command not supported by the transmitter
4 Range error ■ The value is outside the range supported by the
sensor
■ The desired unit of measure is not supported
5 Unspecified error of the
transmitter
The sensor signals an error in the status byte that is
not broken down
CAUTION!
If faults cannot be eliminated by means of the measures listed above, the
instrument must be shut down immediately, and it must be ensured that signal
is no longer present, and it must be prevented from being inadvertently put back
into service. In this case, contact the manufacturer.
If a return is needed, follow the instructions given in chapter 12.1 "Return".
12. Dismounting, return and disposal
WARNING!
Residual media in the dismounted instrument can result in a risk to persons, the
environment and equipment. Take sufficient precautionary measures.
12.1 Return
WARNING!
Absolutely observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, leachate, solutions, etc.).
When returning the instrument, use the original packaging or a suitable transport package.
11. Faults / 12. Dismounting, return and disposal