2 operating, 3 configuration, Operating – WIKA CPH6300 Benutzerhandbuch
Seite 13: Configuration

6 Commissioning, Operation
WIKA Operating Instruction, Model CPH6300 13
14043054
.01
07
/20
12
G
B/
D
6.2
Operating
Connect sensors, turn device on via
key.
After segment test
the device displays some configuration:
if standard measurement is selected
if fast measurement is selected
if peak value detection is selected
After that the device is ready for measuring.
6.3
Configuration
Some menu points depend on current device settings (e.g. some menu points are
locked, if the logger memory contains data sets).
To change device settings, press “MENU”
for 2 seconds. This will activate the configuration
menu (main display: “SEt”). Pressing “MENU”
changes between the menus points, pressing
jumps to the referring parameters. The parameters can be changed with
or
. (Switch
through the parameters with
.)
Pressing “MENU”
again jumps back to the main configuration menu and saves the settings.
“STORE”
finishes the configuration and returns to standard measuring operation.
Pressing “MENU” and “STORE” at the same time for more than 2 seconds will reset
the device to factory defaults.
If there are data sets stored and logger is set to “manual recording” (“Func Stor”) the
first menu point displayed is “rEAd Logg” (see chapter 6.5 “Data Logger”)
If no key is pressed for more than 2 minutes the configuration will be aborted. All
changes will not be saved!
GB