WIKA CPH6300 Benutzerhandbuch
Seite 22

6 Commissioning, Operation
22 WIKA Operating Instruction, Model CPH6300
14043054
.01
07
/20
12
G
B/
D
One data set contains: (1-channel version):
■
Measuring value at the time of the recording
■
“
CALC off”:
min-peak, max-peak since the last recording
■
“
CALC aktiv”
1)
: Calculated value at the time of the recording and dummy value
■
Time and date of the recording
is displayed if logger storage is full.
One data set contains: (2-channel version):
■
Sensor 1: measuring value at the time of the recording
■
Sensor 1: min-peak, max-peak since the last recording
■
Sensor 2: measuring value at the time of the recording
■
Sensor 2: min-peak, max-peak since the last recording
■
Difference sensor 1-sensor 2: measuring value at the time of the recording
■
“
CALC off”:
Difference sensor 1-sensor 2: min-peak, max-peak since the last
recording
“CALC aktiv”
1)
: Calculated value at the time of the recording and dummy value
■
Time and date of the recording
is displayed if logger storage is full.
b) Read manual recordings:
Saved data sets can be viewed both with Software GSOFT and directly on the device display.
Do not change the pressure sensor if manual recording is selected and values are
already stored, because otherwise invalid data may be read-out. The pressure
sensor used during the recording has to be connected!
Press for 2 seconds:
is displayed
„rEAd LoGG” is only displayed if data sets have been already stored. Otherwise the
configuration menu is displayed:
Press shortly: Change between measuring values, measuring point and
date+time of the data set
or
Change between different data sets
End display of recordings
1)
CALC-Function: see chapter 6.4.5
GB