WIKA CTH6200 - Handbuch (Seite 15)

WIKA Betriebsanleitung Hand-Held Thermometer
2146872 09/2004 GB/D
15
GB
WIKA Operating Instructions Hand-Held Thermometer
Hand-Held Thermometer
CTH 6200
3. Operation of logger
The device supports two different logger functions:
"Func-Stor": each time when the key: ´Store/Quit´ is pressed a
measurement will be recorded.
"Func-CYCL": measurements will automatically be recorded each
interval, which was set in the logger menu ´CYCL´
until the logger will be stopped or the logger memory
is full. The recording is started by pressing key:
´Store/Quit´ for 2 seconds.
The logger records 1 measurement result each time.
For the evaluation of the data the WIKA Data logger evaluation
software GSOFT (V 1.7 or higher) has to be used. The software
also allows easy configuration and starting of the logger.
When the logger is activated (Func Stor or Func CYCL) the hold
function is no more available, the key: ´Store/Quit´ is solely used
for the operation of the logger functions.
3.1 Func-Stor": Storing single measurements
Each time when key: ´Store/Quit´ is pressed a measurement and
its time stamp will be recorded.
The recorded data can be viewed either in the display (when
calling the configuration an additional menu "REAd LoGG" is
displayed, see below) or by means of the interface and a PC with
GSOFT-software.
Max. number of measurings: 99
A measuring max. contains:
■ Current measuring value at the time of recording
■ Min.-Peak, Max.-Peak since last recording
■ Time and date of the recording
After each recording "St. XX" will be displayed for a short time. XX
represents the number of the recording.