Hand-held thermometer cth 6200, Fault and system messages – WIKA CTH6200 Benutzerhandbuch
Seite 19

WIKA Betriebsanleitung Hand-Held Thermometer
2146872 09/2004 GB/D
19
GB
WIKA Operating Instructions Hand-Held Thermometer
Hand-Held Thermometer
CTH 6200
6. Fault and system messages
Display
Meaning
Remedy
Replace battery
Check power supply, replace it when
necessary
Replace battery
Check power supply, replace it when
necessary
Replace battery
Netzgerät überprüfen / austauschen
Disconnect battery or power supply,
wait some time, re-connect
Return to manufacturer for repair
Connect sensor to socket
Return to manufacturer for repair
Is the value exceeding the measuring
range specified?
-> measuring value to high!
Check probe
Return to manufacturer for repair
Check: is the value below the
measuring range specified?
-> measuring value to low!
Check probe
Return to manufacturer for repair
-> Set resolution to 0.1 ° or Auto
-> Set resolution to 0.1 ° or Auto
Return to manufacturer for repair
Do not leave the specified range
Low battery voltage, device will coninue
to work for a short time
If mains operation:
wrong voltage
Battery empty
Mains operation without battery:
wrong voltage
Battery empty
Mains operation without battery:
wrong voltage
System error
Device defective
Sensorerror: son sensor connected
Sesnor / cable or device defective
Value exceeding measuring range
Wrong probe connected
Sensor / cable or device defective
Value below display range
Wrong probe connected
Sensor / cable or device defective
Value exceeding display range
Value below display range
System error
Out of range
No display
or strange
symbols,
device is not
responding
to input
----
Err.1
Err.2
Err.3
Err.4
Err.7