TechniSat SkyCable QPSK/DVB-T CI TWIN - Handbuch (Seite 64)

64
EN
3.
Sat SR:27500Kb
Symbol-rate
The symbol rate is entered in kbaud using the numeric buttons.
The data is transferred when the OK button is pressed.
4. LNB Frq:10600MHz LNB local oscillator frequency (LO)
The LO frequency is entered in MHz using the numeric buttons and
depends on the satellite frequency range.
Low band from 10.70–11.70 GHz ≙ LO = 9750 MHz
High band from 11.70-12.75 GHz ≙ LO = 10600 MHz
The data is transferred when the OK button is pressed.
09750MHz = LO frequency for low band
10600MHz = LO frequency for high band
5. LNB Set:18V/22kHz Controlling the integrated multi-switch
Press the ► or ◄ cursor button to set the control voltage for the
integrated multi-switch and hence select the SAT IF level. The data is
transferred when the OK button is pressed after selection.
13V/ OK = Vertical low band
18V/ OK = Horizontal low-band
18V/22K = Horizontal high-band
13V/22K = Vertical high-band
6.
CI:No Module
CAM type
Displays the designation of an available CAM. If no CAM is available the
message “No Module” appears.
7.
CI:programm
CAM program selection
Here you can select which of the programs available in the reception
signal are unlocked by the smart card. Only functions when a CAM is
available.
8.
Output:program
Output program selection
Press the OK button to access the selection menu.
The display shows
C1 F:Servicename
Press the ► or ◄ cursor button to display the service in the transport
stream and press the OK button to select. The selected service is
indicated by an asterisk
C1*F:Servicename
When all the services have been selected, press EXIT and confirm with
OK. All the selected services are now transferred to the output.
3.10.2.4 Display Line 3
Select line 3 as described in 3.10.2.2
If the flashing cursor is located in the third line the following sub-items can
be called up by repeatedly pressing the Menu button:
1.
RF Frq:330,00MHz = RF output frequency
2.
RF Attn:00dB = RF T-pad attenuator
3. QAM SR:6900KB = Output symbol rate
4. QAM Mode:256 = Modulation process
5.
I/Q Inver:YES = Invert modulation spectrum
6.
Modulation:YES = Modulation On/Off
7.
QamSource:Tuner
= Signal source for QAM modulator
02:QPSK->QAM A
Tuner Lock:Yes
RF Frq:330,0MHz
P010,010,110,103