Permanent switching of usb 2.0 devices, Enabling permanent switching of usb 2.0 devices – Guntermann & Drunck TradeSwitch8-USB Benutzerhandbuch

Seite 58

Advertising
background image

Switching

12 · G&D TradeSwitch8-USB

Permanent switching of USB 2.0 devices

In the default settings of the KVM switch, KVM data and the data of devices con-

nected to the »USB 2.0 Devices« interface are forwarded to the computer of the

active channel.

Enable USB pinning (see page 33) if you want to permanently switch the data of

devices connected to the »USB 2.0 Devices« interface to a defined channel. The per-

manent switching of these devices (see page 12) remains the same even when

switching the KVM channel.

Enabling permanent switching of USB 2.0 devices

How to permanently switch USB 2.0 devices to a channel:
1. To activate the setup mode, press

Hotkey+Backspace

(default:

Alt Gr+Backspace

) at the same time.

If the hotkey delay is enabled, press and hold the key combination for seven

seconds.

2. Enter one of the following key combinations:

U1

 Permanent switching of USB 2.0 devices to channel 1

U2

 Permanent switching of USB 2.0 devices to channel 2

U3

 Permanent switching of USB 2.0 devices to channel 3

U4

 Permanent switching of USB 2.0 devices to channel 4

U5

 Permanent switching of USB 2.0 devices to channel 5

U6

 Permanent switching of USB 2.0 devices to channel 6

U7

 Permanent switching of USB 2.0 devices to channel 7

U8

 Permanent switching of USB 2.0 devices to channel 8

Disabling the permanent switching of USB 2.0 devices

How to disable the permanent switching of USB 2.0 devices:

1. To activate the setup mode, press

Hotkey+Backspace

(default:

Alt Gr+Backspace

) at the same time.

If the hotkey delay is enabled, press and hold the key combination for seven

seconds.

2. Press

U

and immediately

0

.

IMPORTANT:

Press

U

and immediately the

number

of the desired channel.

NOTE:

The LED

Active

shows the switching status (see page 6).

NOTE:

After disabling the permanent switching of USB 2.0 devices, the devices are

switched to the active KVM channel (see page 7).

Advertising