AEG BP5013021M - Handbuch (Seite 10)

Button Function Description
Temperature To check the oven temperature or the core tem-
perature of the food probe (if applicable). Use
only while an oven function is in operation.
5.6 Heat-up and residual heat
indicator
When you activate an oven function, the
bars in the display
come on one by
one. The bars show that the oven tem-
perature increases or decreases.
When you deactivate the appliance, the
display shows the residual heat indicator
if the temperature in the oven is
more than 40 °C. Turn the temperature
knob left or right to show the oven tem-
perature on the display.
5.7 Steam Cooking
1. Set the function .
2. Press the cover of the water drawer
to open it. Fill the water drawer with
water until the Tank Full indicator
comes on. The maximum capacity of
the tank is 900 ml. It is sufficient for
approximately 55 - 60 minutes of
cooking.
Use only water as the liquid. Do
not use filtered (demineralised)
or distilled water. Do not use
other liquids.
Do not put flammable or alcohol-
ic liquids (grappa, whisky, co-
gnac, etc.) into the water drawer.
3. Push the water drawer into its initial
position.
4. Prepare the food in the correct
cookware.
5. Set the temperature between 130 °C
and 230 °C. Steam cooking does not
give good results in temperatures
above 230 °C.
6. Empty the water tank after the steam
cooking is completed.
WARNING!
Wait a minimum of 60 minutes
after each use of the True Fan +
Steam function in order to pre-
vent hot water from exiting the
water outlet valve.
5.8 Water Tank indicator
When the Steam cooking operates, the
display shows water tank indicator. Wa-
ter tank indicator shows the level of the
water in the tank.
•
— Water tank is full. An acoustic
signal sounds when the tank is full.
• — Water tank is half full.
•
— Water tank is empty. An acous-
tic signal sounds when the tank must
be refilled.
If you put too much water into
the tank, the safety outlet moves
the excess water to the bottom
of the oven.
Remove the water with a sponge
or cloth.
5.9 Emptying the water tank
Make sure that the appliance is
cool before you start to empty
the water tank.
1. Prepare the draining pipe (C), inclu-
ded in the same package with the
user manual. Put the connector (B)
onto one of the ends of the draining
pipe.
2. Put the second end of the draining
pipe (C) into a container. Put it at a
lower position than the outlet valve
(A).
B
C
A
10 www.aeg.com