LumaSense Technologies PI 6000 - Handbuch (Seite 28)

Programmable controller PI 6000
28
Housing: Plastic housing (flame-retardant Noryl), 48 x 96 x 141 mm (H x W x D) in
accordance with DIN 43 700 with screw clips for front panel mounting
Front panel cut-out: 45 +0.6 x 92 +0.8 mm
Installation depth required: ≥ 165 mm with terminals and cables
Connections: Plug-in terminals, wire cross-section 0.14... 2.5 mm² (AWG 26...14),
with ferrules: 0.5... 1.5 mm²
2.1 Appropriate
use
The PI 6000 is a fast programmable PID controller that is optimised for use with an IMPAC series 5, 12, 50,
140, 510 or 520 digital pyrometer as a transducer and therefore provides an extremely fast controller cycle
time of only 250 µs.
The display and controls on the front of the unit are designed for the control and monitoring of a programmed
PID control system. The unit can store 9 control programs with up to 20 temperature steps ("segments"),
long-term control systems are also possible with the continuous mode. The PI 6000 is programmed using a
PC to prevent inadvertent changes to the entries by the user. A PC is not necessary for the operation of the
controller, the unit is controlled directly using the buttons on the PI 6000.
2.2
Scope of delivery
Programmable controller PI 6000 with fastening clips, CD with InfaWin PC software, operating instructions.
3 Safety
This section offers an overview about important safety aspects.
Additionally in the several sections there are mandatory safety aspects to avert danger. These aspects are
indicated with symbols. Labels and markings at the instrument have to be noticed and keep in a permanent
readable condition.
3.1 General
Each person working with the PI 6000 must have read and understood the user manual before operation.
Also this has to be done if the person already used similar instruments or was already trained by the manu-
facturer.
The PI 6000 has only to be used for the purpose described in the manual. It is recommended to use only
accessories offered by the manufacturer.
3.2
Laser targeting light
For easy alignment to the measuring object the pyrometers can be equipped with a laser targeting light. This
is a visible red light with a wavelength between 630 and 660 nm and a maximum power of 1 mW. The laser
is classified as product of laser class 2.
Caution: Do not look directly into the laser beam!
Laser class 2 according to IEC 60825-1-3-4
Safety regulations:
• Never look directly into the laser beam. The beam and spot can be watched safely from side.
• Make sure that the beam will not be reflected into eyes of persons by mirrors or shiny surfaces.
3.3 Electrical
connection
Follow common safety regulations for mains voltage (230 or 115 V AC) connecting additional devices operat-
ing with this mains voltage (e.g. transformers). Touching mains voltage can be mortal. A non expert connec-
tion and mounting can cause serious health or material damages.
Only qualified specialists are allowed to connect such devices to the mains voltage.