ALTANA Temp-Chart - Handbuch (Seite 101)

temp-chart Software temp-gard Hardware
24
How to Analyze Acquired Data
All measurements that have been acquired with this software were saved under a certain
name. They can be searched for and opened by entering that particular name in the
command Read Data of the File menu at any later point of time.
For looking at the temperature curves, switch to the chart page.
Draw the mouse over the curves, and the program will indicate the data values of the time
and temperature axes at the bottom left hand side.
If you just want to look at a certain section of the measurement, you can either
x
move the axes with the help of the mouse, or
x
pull a square over the section of interest by keeping the mouse button pressed
On the profile page, you can look at the temperature profile.
By simultaneously pressing the
STRG + F keys, you can choose between two perspectives.
(Command New View in the View Menu)
To look at the characteristic values of the measurement, go to the analysis
notebook.
The analysis notebook consists of several pages containing the data values analysis
results of all sensors. You can shift between the pages by clicking on the index-tab at the
top margin, or by using the commands in the Window Menu.
How to Print a Protocol
temp-chart offers a variety of protocol types. In general, however, the standard protocol is
the one most commonly used for print-outs. It shows not only the comments and
measurement descriptions but also the charts and selected analysis results.