ALTANA Temp-Chart - Handbuch (Seite 139)

temp-chart Software temp-gard Hardware
62
With the R button in the toolbar, all of the selected reference curves are hidden or
shown. If you want to hide a particular curve, you must remove by clicking off the option
box on this page.
With the Delete button you can undo a previously made allocation, i.e. you can allocate
no reference curve to the template.
The Command Acquisition Setup in the Index-tab Settings at the Lower Screen
Margin
Use this command to open the setup page Acquisition setup where you can define
parameters, which are important for the measurement. You can only fill in the columns
when you have opened a template.
Please be particularly careful when filling in the input boxes, as these settings cannot be
changed any more after the measurement.
Indicate the desired times in the Sampling Interval and Duration boxes. Please note that
some parameters may not be supported by your instrument.
Please select one of the following options in the Start Trigger option box:
None
the measurement is started immediately – with the temp-gard after
pressing the start key
Threshold the measurement is started as soon as sensor 1 exceeds the set
threshold value
Delay the measurement is started after the set waiting time