Vanguard Managed Solutions Vanguard 6435 - Handbuch (Seite 3)

Notice (continued)
Proprietary Material
Information and software in this document are proprietary to Vanguard Managed Solutions
(or its Suppliers) and without the express prior permission of an officer of Vanguard
Managed Solutions may not be copied, reproduced, disclosed to others, published, or used, in
whole or in part, for any purpose other than that for which it is being made available. Use of
software described in this document is subject to the terms and conditions of the Software
License Agreement.
This document is for information purposes only and is subject to change without notice.
Radio Frequency Interference Regulations
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
Changes or modifications not expressly approved by Vanguard Managed Solutions could
void the user's authority to operate the equipment.
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
This is a Class A product. Operation of this equipment in a residential environment may
cause radio interference, in which case the user may be required to take adequate measures to
correct the interference at his/her own expense.
This product was verified under test conditions that included use of shielded DTE cable(s).
Leased line cables with 1.5 turns through a ferrite cylinder were also used. Use of different
cables will invalidate verification and increase the risk of causing interference to radio and
TV reception.
You can obtain the proper cables from Vanguard Managed Solutions.
Telecommunications Regulations
Equipment that complies with Part 68 of the FCC rules includes a label or permanent
marking on the printed circuit board that connects to the network that contains, among other
information, the FCC registration number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company. A plug
and jack used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions
for details.