Vanguard Managed Solutions Vanguard 6435 - Handbuch (Seite 72)

3-4 Installation and Replacement
Installing The Vanguard 6435/6455
Installing the Standalone Version
How to Choose a
Site Before you install a standalone version of the Vanguard 6435/6455, select a site for
the device.
Choose a site that is within an appropriate distance of a power source. Depending on
your application, and the country in which the Vanguard 6435/6455 is to operate, the
power source must be a grounded 110 to 220 Vac outlet.
Leave at least 2 inches (5 cm) of clearance in front of the front panel, to allow you to
see the front panel display, and behind the unit for cable clearances (see Figure 3-2).
For proper ventilation, leave 2 inches (5 cm) of clearance on the sides.
The site should be free of accumulated dust and environmental extremes. Refer to
Appendix A, Specifications for details.
Figure 3-2. Proper Cable and Air Clearance
Caution
Vanguard 6435/6455 devices should be used in environments designed for
computers and electronic equipment. In areas susceptible to lightning, take
precautions to prevent damage to electronic equipment. Contact your telephone
company or an electronic accessories vendor for information on lightning protection
equipment. Customers experiencing problems caused by surges from lightning have
eliminated such problems by installing appropriate surge suppressors on power and
data lines connected to the Vanguard 6435/6455 devices.
Minimum 2 inches (5 cm)
Front and Rear
Minimum 2 inches (5 cm)
on either side for ventilation.
Note: Do not remove the
rubber feet from the
bottom of the unit. They
allow for proper air
flow.