Vanguard Managed Solutions Vanguard 6435 - Handbuch (Seite 34)

Configuring the
Parameters This table explains how to configure the two parameters:
After you complete this procedure, review the alarm log for disabled ports. If
necessary, reduce the resource requirements allocated to the other ports and stations
and repeat the above procedure.
Step Action
1 From the Main menu, select Configure.
2 From the Configure menu, select Node.
3 Press ENTER until the parameter *SHARED Dynamic Port
Creation Heap Size appears. Enter the maximum value (16000000).
4 Press ENTER again. The parameter *LOCAL Dynamic Port
Creation Heap Size appears. Type the maximum value (16000000).
5 Press ; (semi-colon) and then press ENTER.
6 Perform a Node Boot (Warm).
The node reboots and the Ease of Configuration function is enabled.