Baumer BA ZADM023 - Handbuch (Seite 63)

Seite / Page 63
7 Programming the measurement type
The PosCon starts in Run mode. The LEDs indicate the current type of
measurement.
Note: The type of measurement and the tolerance limits for the switch-
ing output remain stored even after power down.
Two buttons help to program the sensor easily.
The MOD and PROG buttons are for programming the type of measurement.
The SET button is for setting the threshold (set points) of the switching out-
put.
Press the PROG button for more than 2 seconds to
enter the programming mode. The measurement
type indicator LED is now blinking.
To return to run mode after setting the right type of
measurement, press the PROG button again for
more than 2 seconds.
PROG
MOD
1 2 3
L R
min. 2 sec
PRO
MOD
SET