TechniSat TechniRouter 9/2x4 G - Handbuch (Seite 28)

28
EN
Once the last satellite receiver was switched off in the above mentioned manner, the
TechniRouter is not consuming power anymore. If only one base unit is in use, the LNBs
will be automatically turned off.
The system operates in a particular energy-efficient manner.
Should there be a need for further subscriber connections, additional distributor lines can
be made available with the help of a multiswitch accessory (see point 5).
The TechniRouter from this family are return-path-compatible.
2 Safety Advices
Please read the following safety notes carefully prior to assembly.
The manufacturer accepts no responsibility for damage caused by inappropriate operation
or by non-compliance with safety precautions.
•
The components must be assembled in a dry place, on a level and fire-resistant
surface.
•
Do not cover the ventilation slits of the components.
•
Do not install the device within the roof insulation.
•
Ensure that the device is switched off when you install it.
•
The antenna unit must be earthed. The first device after the external unit must be
connected to the building earth.
•
The antenna unit must be protected against lightning strikes in accordance to relevant
requirements; please see point 4.3 for more details.
Please pay careful attention to the information contained!
•
The relevant European standards and VDE (Association of German Electrical
Engineers) provisions to guarantee electrical safety must be complied with.
•
It is necessary to comply with national law regulating broadcast receiving systems.
•
Never open the unit housing.
Any intervention necessary should only be carried out by specialized staff.
In the following cases, you should disconnect the unit from the mains power supply
and consult a qualified technician:
•
the unit was exposed to moisture, or liquid has run into the unit,
•
in the event of malfunctions,
•
in case of severe external damage.