TechniSat TechniRouter 9/2x4 G - Handbuch (Seite 36)

36
EN
For twin tuners (DVRs), two user bands are required. The frequencies of the user bands
and their PIN-Codes are listed on page 1.
We recommend,
•
to keep these assembly instructions (and the proof of purchase) in a safe place in
case of loss, repair or new acquisition,
•
not to use the PIN code feature when distributing within a residence,
•
the use of the PIN code when using the same subscriber line for various residences,
•
to attach the label supplied on delivery to the relevant receiver (preferably on the rear),
•
to note the locations and/or names of subscribers in the table on page 1.
Note:
A single incompatible or wrongly configured receiver (e.g. Universal LNB selected)
may disrupt the commands for all other devices connected to the same subscriber
line, thus making transmission (at least during active operation but also program
changes of others) impossible. We recommend the use of TechniPro 600-10E if
multiple dwelling units need to be supplied from the same subscriber line.
Configuring the receiver unit:
We will now outline how to configure the TechniSat receivers (see also the respective
operating instructions), although this procedure may not apply to other receivers.
Please check by referring to the operating instructions supplied with your receiving
unit.
4.6.1 Initial Operation of the System
•
During the assignment of the user band, all other receiver units - connected to the
same output of the TechniRouter - should be switched off or even better disconnected
from the same. Otherwise this may cause malfunction of the assignment process!
•
To be on the safe side, initially disconnect all receiver units from the TechniRouter and
subsequently switch on and set up each one individually.
•
To initiate this procedure, go to the menu in the receiver or TV Settings -> Antenna
settings, enter the configuration dialog of the desired satellite position and select the
LNB type SatCR LNB or SatCR LNB (PIN) at the same time.
•
When selecting the LNB type SatCR LNB (PIN), an additional factory preset PIN code
needs to be entered. You can find this 3-digit random number on the labels supplied
on delivery (see above). This helps to ensure that the relevant user band assigned to
the receiver is protected against third party access, regardless at which outlet it is
plugged into within the subscriber line.
•
Based on the respective receiving unit, it may now be necessary to manually enter
one of the frequencies in the configuration dialog of the SatCR as well as the relevant
user band number (channel or subscriber number, Nos. 1 to 8).
•
Several sat receivers offer an automatic channel search and you can subsequently
select the desired choice from a list.
•
If, during the above-mentioned automatic channel search, no SCR channels are found
or if the test transponder is not received, repeat the setup. Ensure, while doing so, that
no other receiver connected to the same line is currently switched on.
•
Repeat the settings for the second sat position.