TechniSat TechniRouter 9/2x4 G - Handbuch (Seite 37)

37
EN
4.6.2 Adding of an Further Receiver during Running Operation
•
This procedure can only be accomplished, when one or more user band/s are still
available. Please do so at a time, when a minimal number of people are using the
same subscriber line or give the subscribers advance notice.
•
Switch on the receiver, but ensure the antenna cable is not connected.
•
Enter the menu in the receiver or TV Settings -> Antenna settings, to enter the
configuration data for the satellite orbit received and select LNB type SatCR LNB or
SatCR LNB (PIN).
•
Now connect the antenna cable and manually enter the user band and potentially the
frequency and PIN code as well. Automatic setup should be avoided, since this will
disrupt other subscribers and also cause malfunction of the assignment process.
The successful assignation of the selected user band can be confirmed with the
level/quality display (toward the bottom of the on-screen display) for the adjusted test
transponder. After exiting the menu, programs can now be selected via the TechniRouter
for the received satellite position as with conventional receiving equipment. The user band
assignment for this receiving device is now completed.
When restarting the receiver, the SCR mode is activated from the beginning on.
4.6.3 Traffic-Indicator
The traffic indicator helps to inform you about errors.
Green LED:
•
illuminated: At least one receiver is delivering the operating voltage.
•
off: Short circuit or overload via this output cable.
Red LED, flashes, when triggered by the receiver:
•
flashing irregularly: At least one subscriber is changing the program
(normal status).
•
flashing regularly: At least one receiver has not found any program.
•
illuminated continuously: The LNB type for at least one of the receivers is set up
incorrectly.
Further hints:
•
Each available channel frequency can principally only be assigned to one receiver.
•
Within a single residence (but only there), however, with time-delayed operation and
reciprocal arrangement, the same receiving channel can be assigned to two receivers.
•
Please remain patient during the set-up process, since certain receivers are very slow.
•
After dis- and reconnecting the subscriber line to the TechniRouter or after a
power failure, it may take some considerable time until the final receiver has
been able to relocate the program last set. In this case, a single program change
at one of the active receivers may help.
•
Please terminate the terminal socket during periods of non-use with a DC decoupled
75Ω resistor (Art. No. 0002/3074).