LumaSense Technologies ISR 50-LO - Handbuch (Seite 49)

INFRATHERM pyrometer ISR 50-LO
49
10.9 Listing (analyzing)
For reconsider the measured values in
this field all measured data appears in a
numeric list.
The date beside the time gives more exactly
values to see what happened on time units
smaller 1 s. The value specifies the time in
seconds after midnight (0:00 h). The amount of
data depends on the frequency that readings
were taken (settings at 10.12 PC sampling
rate). As the amount of data increases, so does
the amount of storage space required to save it.
In order to save room, all .i12 data files are
stored by a binary code.
10.10 Trend output (analyzing)
The graph’s curve depicts the
temperature change over time
within the specified temperature
range.
Additionally, other information appears in
this window; such as recorded time (x-axis)
and temperature in degrees (y-axis) as well
as the time and temperature at the vertical
cursor line which can be dragged with the
mouse.
Selecting the Trend output initially causes
all the saved data to be displayed.
If the data exceeds an amount that can be
represented reasonably, you may “Zoom“ in
on a partial segment using the mouse (such
as the segment represented in the example).
Under “Total” you can return to the represen-
tation of the entire curve.
Note: The last reading is saved in the standard.i12 file and automatically appears in this
form upon opening Listing or Trend output.
If file open was loaded using another file, the previous file will be overwritten and
replaced by the standard.i12 file.
10.11 Output .TXT file (analyzing)
The same file as under „Output listing” may be converted into a text file and can be easily opened,
for example with EXCEL. EXCEL will automatically correctly format the columns with the default
import settings (tab as separator).
10.12 PC sampling rate (time interval between two measurements)
This function sets a time interval. After each interval one meas-
ured value is stored on the PC. The bigger the time interval the
smaller will be the stored file. This function is mainly used for
long term measurements.