Burkert Type 8025 - Handbuch (Seite 35)

33
Operatingandcommissioning
8 opERATING AND commISSIoNING
8.1 Safety instructions
Warning
risk of injury due to nonconforming operating.
Nonconforming operating could lead to injuries and damage the device and its surroundings.
▶ The operators in charge of operating must have read and understood the contents of this manual.
▶ In particular, observe the safety recommendations and intended use.
▶ The device/installation must only be operated by suitably trained staff.
Warning
Danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
operating instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device / the installation must only be commissioned by suitably trained staff.
▶ Before commissioning the device, enter the K factor of the fitting used. See chap. “8.6.3”.
8.2 operating levels of the device
The device has two operating levels: the Process level and the Configuration level.
The Process level makes it possible:
• to read the flow rate measured by the device, the value of the current transmitted on the 4-20 mA analogue
output, the values of both the daily and main totalizers.
• to reset the daily totalizer.
• to access the Configuration level.
The Configuration level comprises three menus (Parameters, Test and Information) and makes it possible:
• to set the device parameters.
• to test some device parameters.
• to read, when the status LED of the device is orange or red, the warning and fault messages generated by the
device.
Table 3: Default settings of the device
Function Default value
LANGUAGE English
UNIT of the flow rate l/min
UNIT of the totalizers litre
English
Type 8025 UNIVERSAL