Burkert Type 8025 - Handbuch (Seite 46)

44
Operatingandcommissioning
8.6.5 configuring the outputs (general diagram)
OUtPUt AO1
0......9
DO1 PULSE
hYStERES.
wiNDOw
wARNiNG
DO2
DO3
REtURN
hYStERES.
wiNDOw
Parameterizing the 4-20 mA analogue output, AO1. See chap.
“8.6.6”.
Configuring the transistor output DO1 as a pulse output. See
“Figure 36”, chap. “8.6.8”.
Configuring the transistor output DO1 to switch a load
depending on two threshold values. See “Figure 39” and
“Figure 38”, chap. “8.6.8”.
If the device is equipped with relays, configuring the relay
output DO2 or DO3 to switch a load depending on two
threshold values. See “Figure 39”, chap. “8.6.8” and “Figure
42” chap. “8.6.12”.
Configuring the transistor output DO1 to switch a load when a
warning message is generated by the device. See “Figure 41”
chap. “8.6.8”.
wARNiNG
If the device is equipped with relays, configuring the relay
output DO2 or DO3 to switch a load when a warning message
is emitted by the device. See “Figure 43” chap. “8.6.12”.
0......9
0......9
Activate / deactivate the generation of a 22 mA current on the
AO1 current output, when the device generates a fault. See
chap. “8.6.7”.
4MA-20MA
ERR. 22MA.
0......9
FiLtER
REtURN
Figure 33: Diagram of the "OUTPUT" parameter of the Parameters menu
8.6.6 Associating a flow rate range to the current output Ao1
The 4-20 mA output provides an electrical current, the value of which reflects the flow rate measured by the
device.
Example of relation between the measuring range and the current output:
4
20
20 180
mA
l/min
English
Type 8025 UNIVERSAL