Burkert Type 8025 - Handbuch (Seite 37)

35
Operatingandcommissioning
8.3 Description of the navigation keys and the status
LEDs
• Selecting the displayed
parameter
• Confirming the settings
Status LED of relay DO3 (LED ON
= contact closed)
• Reading the messages
• Scrolling through the parameters
• Selecting the figure on the left
• Scrolling up the
parameters
• Incrementing the figure
selected
Device status LED: see
following table.
Status LED of relay DO2 (LED ON
= contact closed)
Device status
leD status of the device
Green The device operates correctly.
Orange A warning message is generated.
→
Press the key for 2 seconds in the Process level to access the message. See
chap. “9.3” for the meaning of the message.
Furthermore, a relay output (DO2 or DO3) or the transistor output DO1 switches if it is
configured in the "WARNING" mode (see Figure 41
or Figure 43)
Red An error message has been generated and the current output sends out a 22 mA current (if
parameter "ERR. 22mA" is set to "ENABLED". See chap. “8.6.7”. ) .
→
Press the key for 2 seconds in the Process level to access the message. See
chap. “9.3” for the meaning of the message.
Blinking,
whatever the
colour
A check for the correct behaviour of the outputs is running (see chap. “8.7.3”)
English
Type 8025 UNIVERSAL