1 choosing the display language, Choosing the display language – Burkert Type 8025 Benutzerhandbuch
Seite 40
38
Operatingandcommissioning
LANGUAGE
Process level
UNit
K-FACtOR
OUtPUt
FiLtER
tOtAL
CUt-OFF
BACKLit
END
12.6 L/MiN
0......9
Choosing the display language
SAVE N/Y
Choosing the flow rate unit, the number of decimals and the unit the totalizers are
displayed in.
Entering the K factor of the fitting used or have it defined through a Teach-In
procedure.
Parameterizing the 4-20 mA current output (AO1) and configuring the transistor
output (DO1) and, if the device is equipped with, the 2 relay outputs (DO2 and DO3).
Choosing the filter level of the measured flow rate, on the displayed flow rate and the
AO1 current output.
Resetting both totalizers.
Entering the measured flow rate value below which the device sets the measured flow
rate to 0 with effect on the display, the outputs and the totalizers.
Setting the brightness of the display and how long it stays ON, or deactivating the
backlight.
Saving the changes made within the Parameters
menu or not. If the changes are saved, the device
operates with the new settings.
Figure 27:
Diagram of the Parameters menu
8.6.1
choosing the display language
When the device is energized for the first time, the display language is English.
LANGUAGE
ENGLiSh
DEUtSCh
FRANçAiS
itALiANO
ESPANOL
0......9
→
Confirm the displayed language: the
selected language is immediately active.
UNit
Figure 28:
Diagram of the "LANGUAGE" parameter of the Parameters menu
→
If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER
to save the settings or not and go back to the Process level.
English
Type 8025 UNIVERSAL