Panel mounting, Pipe mounting – FMC Corporation - Talstar 80 Benutzerhandbuch
Seite 24
Installation
Proline Promass 80 PROFIBUS PA
24
Panel mounting
1.
Prepare the opening in the panel as illustrated in the diagram.
2.
Slide the housing into the opening in the panel from the front.
3.
Screw the fasteners onto the wall-mount housing.
4.
Screw threaded rods into holders and tighten
until the housing is solidly seated on the panel wall. Afterwards, tighten the locking nuts.
Additional support is not necessary.
a0001131-ae
Fig. 18:
Panel installation (wall-mount housing)
Pipe mounting
The assembly should be performed by following the instructions in the diagram.
"
Caution!
If a warm pipe is used for installation, make sure
that the housing temperature does not exceed the max. permitted value of +60 °C (+140 °F).
a0001132-ae
Fig. 19:
Pipe mounting (wall-mount housing)
245 (9.65)
~110 (~4.33)
210 (8.27)
+0.5 (+0.019)
–0.5 (–0.019)
+0.5 (+0.019)
–0.5 (–0.019)
mm (inch)
Ш 20…70
(Ш 0.79…2.75)
~
~ 6.1)
155 (
mm (inch)