FMC Corporation - Talstar 80 - Handbuch (Seite 37)

Proline Promass 80 PROFIBUS PA Operation
37
5.2 Local display
5.2.1 Display and operating elements
The local display enables you to read all important parameters directly at the measuring point and
configure the device using the "Quick Setup" or the function matrix.
The display consists of four lines; this is where measured values and/or status variables (direction
of flow, empty pipe, bar graph, etc.) are displayed. You can change the assignment of display lines
to different variables to suit your needs and preferences (
→ "Description of Device Functions"
manual).
A0001141
Fig. 26: Display and operating elements
1 Liquid crystal display
The two-line liquid crystal display shows measured values, dialog texts, fault messages and notice messages. The
display as it appears when normal measuring is in progress is known as the HOME position (operating mode).
– Top line: shows main measured values, e.g. volume flow, [e.g. in ml/min]
– Bottom line: shows the totalizer reading [e.g. in m
3 ]
– Bargraph display, tag name
2 O/ S keys
– HOME position
→ Direct access to totalizer values and actual values of inputs/outputs
– Enter numerical values, select parameters
– Select different function groups within the function matrix
Press the +/- keys (X) simultaneously to trigger the following functions:
– Exit the function matrix step by step
→ HOME position
– Press and hold down +/– keys for longer than 3 seconds → Return directly to HOME position
– Cancel data entry
3 F key (Enter key)
– HOME position
→ Entry into the function matrix
– Save the numerical values you input or settings you changed
Esc
E
+ -
1
3 2
+48.25 xx/yy
+3702.6 x