FMC Corporation - Talstar 80 - Handbuch (Seite 36)

Operation Proline Promass 80 PROFIBUS PA
36
5 Operation
5.1 Quick operation guide
The user has a number of options for configuring and commissioning the device:
1. Local display (option)
→ Page 37
The local display enables you to read all important variables directly at the measuring point,
configure device-specific parameters in the field and perform commissioning.
2. Operating programs
→ Page 42
The configuration of profile and device-specific parameters is primarily done via the PROFIBUS
interface. You can obtain special configuration and operating programs from various
manufacturers for these purposes.
3. Jumpers/miniature switches for hardware settings
– Configuring the device address
→ Page 45
– Hardware write protection
→ Page 44
You can make the following hardware settings using a jumper or miniature switches on the
I/O board:
• Device bus address configuration (for hardware addressing)
• Hardware write protection enabling/disabling
a0001318
Fig. 25: Methods of operating PROFIBUS PA
1 Local display for device operation in the field (option)
2A Configuration/operating programs (e.g. FieldCare) for operation via PROFIBUS PA
2B Configuration/operating program for operating by means of the FXA193 service interface (e.g. FieldCare)
3 Jumper/miniature switches for hardware settings (write protection, device address)
2A
3
1
Esc E - +
Esc
E + -
XXX.XXX.XX
Esc E - +
FXA193
2B