WIKA UPT-21 - Handbuch (Seite 24)

24 WIKA operating instructions process transmitter, model UPT-2x
14068347.01 06/2014 GB/D
GB
6 Commissioning, operation
4. Attach the push-on cap or display and operating unit and screw the case head cover
tight down to the stop.
- Ensure that the case head is tightly closed.
5. Perform a mounting correction.
- Without display, see chapter 8.1 “Performing a mounting correction (offset)”
- Via HART ® , see chapter 8.2 “Configuring the HART  interface”
- With display, see chapter 9.5 “Mounting correction (offset)”
6.2.3 Pin assignments
Angular connector DIN 175301-803 A
1
2
3
+ 1
– 2
Shield GND
Circular connector M12 x 1 (4-pin)
4 3
1 2
+ 1
– 3
Shield 4
With shielded connection cable, connect the cable shield to the internal
grounding screw.

Pin assignment Outlet for connection cable




 Cable gland  Negative power supply terminal –
 Process connection  Ground screw, inside (GND)
 Positive power supply terminal +
Spring-loaded terminal