WIKA CTH6300 - Handbuch (Seite 23)

23 WIKA operating instructions, models CTH6300 and CTH6500
2079988.04 07/2014 GB/D
GB
6. Commissioning, operation
Measurement
parameter
Probe selection (Prob) LCD display
Temperature Pt100 (RTD)
Temperature Fe-CuNi type J
Temperature NiCr-Ni type K
Temperature Fe-CuNi type L
Temperature NiCrSi-NiSi type N
Temperature Pt13Rh-Pt type R
Temperature Pt10Rh-Pt type S
Temperature Cu-CuNi type T
Humidity % r. h.
Flow m/s
Pressure Pa
Hot wire m/s
Confirm the required setting by pressing ENTER/MENU. Press ESC to return to the
measuring mode again.
Make sure that the correct measurement parameter is set for the
connected probe. If a measurement parameter is changed in the Prob
menu and the change confirmed by pressing the Enter key, the standard
calibration is used automatically.
Note on combined probes (temperature and humidity):
Set relative humidity as a measurement parameter for the measuring
channel to which the combined probe is connected. If you want the
temperature value of the connected combined probe to be displayed as
well, deactivate the channel to which no combined probe is connected
(see chapter 6.4.6 “Activate/deactivate measuring channels [Chnl]”.