ALTANA Temp-Chart - Handbuch (Seite 116)

temp-gard Hardware temp-chart Software
39
The Command Zones/Scaling in the View Menu
For showing or hiding the zonebar. This bar, used for scaling the zones, is situated at the
bottom screen margin, above the status bar, if visible as well. Via mouse click, it grants
you quick access to the zone and sensors selection. The zonebar is active when a little
tick appears next to this menu item.
Werkz1
x In the Zone selection box, you can select one of the zones defined on the oven
settings. Only the zone you have selected here is represented in the chart pages and
analyzed in the analysis pages.
x However, you can always activate Total for looking at the entire measurement.
Please note: A partial selection with or without a current zone is always possible with
the help of the mouse. For more information, please refer to the chapter Scaling.
x In the Sensor selection box, you can define a sensor. Its time and temperature
coordinates will then be displayed in the right hand margin of the zonebar. When
moving the mouse into the chart-area, the coordinates of the set sensor will be
displayed in relation to the horizontal mouse position. The vertical position of the
mouse is of no importance here.
x If you do not tick off the Save selection box, however, the vertical mouse position will
also be taken into account. Then the data values of the sensor with the values closest
to the cursor will be displayed, and the name of that particular sensor will automatically
appear in the selection box.