ALTANA Temp-Chart - Handbuch (Seite 91)

temp-chart Software temp-gard Hardware
14
Attention
Secure all cables and make sure that they cannot get tangled up when travelling through
the oven.
x Hang the thermal barrier on the belt and make sure there is enough free space for the
thermocouple probes, the cables and the thermal barrier.
Finishing the Measurement
Attention
All parts can be hot after the measurement.
Please observe the safety information on page 5.
x Remove the hot thermal barrier from the belt wearing appropriate protective clothing
(protective gloves). Open the thermal barrier and press the start/stop key of the data
logger.
x Take out the SRAM card and load down the measurement data to your computer.
Please Note:
After the measurement data are saved on a computer, the card can immediately be used
for the next measurement. Saving a new template on the card is possible but not
compulsory for a subsequent measurement. temp-gard automatically recognizes whether
the previous measurement has already been saved on a computer. If the data has not
been saved yet, a warning is displayed.
Cooling Down the Protective Parts
x Place hot thermal barriers on heat-resistant spacers, a ceramic fiber blanket or
refractory material to ensure uniform cooling. Placing a hot thermal barrier directly
onto a cold surface may cause the housing to deform due to the different cooling rates
of the surfaces.
x Do not remove the cover before the thermal barrier is in place.
x Since the heat absorbed by the thermal barrier continues to affect the temperature of
the heat sink and data logger, remove these parts from the thermal barrier as soon as
the test is completed. Allow them to cool down before further use. In most cases
cooling overnight is sufficient.
x Please observe the safety information on page 5.