ALTANA Temp-Chart - Handbuch (Seite 142)

temp-gard Hardware temp-chart Software
65
Please note:
x The zone axis is not shown when no zones are defined
x The distance axis is not shown when no oven speed was entered
x The scaling of the zone and distance axes cannot be determined: they are always
scaled in analogy to the time axis.
Please remember to operate the Apply button before choosing a new axis or closing this
page. Otherwise, the changes you have made will not become effective.
The Command Grid in the Index-tab Options at the Lower Screen Margin
Use this command to open the option page Grids. Like all entries in the options
notebook, these settings are not only valid for the template or measurement, which is
currently open, but for the entire program.
Under Resolution, you can determine if you want no grids (Off), a Major or a Minor
sectioning.
In Vertical Grid, you can go for no vertical lines (None) resp. choose if you want the grid
lines to refer to the time (Time Units) or the distance axes (Distance Units). In addition,
in Zone Marking, you can determine whether the zone limits are shown.
In Horizontal Grid, you can go for no horizontal lines (None) or choose if you want a
horizontal line drawn for each value on the temperature axis (Temperature).
Please remember to operate the Apply button. Otherwise, the changes you have made
will not become effective.