ALTANA Temp-Chart - Handbuch (Seite 140)

temp-gard Hardware temp-chart Software
63
The Temperature Range option is only supported by the temp-gard instrument. Be sure
to select a range that will not be exceeded by the expected temperatures. However, a
smaller temperature range will increase the measurement accuracy.
In the First Sensor and Number of Sensors options, you can determine which sensors
are connected. Furthermore, you can change the names of the sensors in the sensor
table.
When you click on the Protect SRAM Card option box, the setup cannot be manually
changed afterwards at the temp-gard. This option is invalid for other loggers.
Please do not forget to operate the Apply button, otherwise the changes will not become
effective.
The Index-Tab Options
The Command General in the Index-tab Options at the Lower Screen Margin
Use this command to open the options page General. Like all entries in the Options
Notebook, the settings are not only valid for the template or measurement which is
currently open, but for the entire program.
In Logger Port, please select the serial interface connected to your logger. With the Test
button, you can check which logger the program recognizes.