ALTANA Temp-Chart - Handbuch (Seite 121)

temp-chart Software temp-gard Hardware
44
When the data values are saved on the hard disk, the program will switch to the general
page in the setup notebook asking you to add the information required that was not yet
known when the template was created.
But of course, you can also switch to the other pages in this notebook, for example, to
change the oven settings or sensor names for this measurement. The software will let
you know when you have made a change that has not been saved yet.
If you want to look at the curves, the temperature profile or the data values analysis
results, simply switch to the respective screen page.
The Command Store Setup in the Hardware Menu – Paqs und Logger
Use this command to prepare a datalogger connected to the serial interface of your
computer for a measurement.
First, please load or select a template, which already contains as many settings of the
measurement planned as possible.
Please Note:
Comments regarding the measurement, oven settings, the selection of tolerance and
reference curves and even the critical threshold values are of no critical importance to the
instrument and can be changed later.
The number of sensors or the selected sampling rate, however, cannot be changed
afterwards without having to repeat the measurement.
You should therefore be particularly careful when entering data in the Acquisition setup
page of the Setup notebook.
Attention
Not all dataloggers supported by the instrument have the same abilities. In the case of the
byko-track instruments, for example, the sampling rate is preset, and with the Loggers
2000, you cannot select a temperature range. Please ensure that you are using only such
settings that your instrument is able to accept.