ALTANA Temp-Chart - Handbuch (Seite 138)

temp-gard Hardware temp-chart Software
61
The Name of the tolerance curve can be freely chosen. In case you should need these
reference values in several templates, you can buffer this information with the Load and
Save buttons in a special intermediate file, so that you always have access to them.
With the Fill option box you can determine whether the enveloping curve is filled with a
light shade of grey, or whether only the outlines are shown.
By selecting No in the Smoothing option box, you can linearly link the defined reference
values. When you choose the options Yes or More, however, help values will be created
to obtain as round a curve as possible.
There are two ways of creating reference values:
x Operate the Add button and enter the position (From here) and both limiting values
(Lower and Upper) in the table. Then, the reference values will be shown in the chart.
x Move the cursor into the chart and drag it from the upper to the lower limiting value
while pressing the mouse button. When releasing the button, the program will insert a
new reference value.
In the chart, the reference values are indicated as small circles. These circles can be
moved with the mouse on order to move the reference value.
With the Delete button, the current reference value (blue background) can be deleted
again. The Reset button deletes all reference values.
The Command Reference Curve in the Index-tab Settings at the Lower Screen
Margin
Use this command to open the setup page Reference Curve where you can select a
reference measurement, which will be shown in the chart page for an easier evaluation.
Operate the Search button to select a measurement, i.e. a previously saved temp-chart
file, and click on the option boxes in front of the sensor names you want represented as
reference curves.