ALTANA Temp-Chart - Handbuch (Seite 137)

temp-chart Software temp-gard Hardware
60
This offset can also be changed afterwards by switching to the chart page and moving the
zero zone on the zone axis. Or, you can press the right mouse button in the area of the
temperature curves and select the command Oven Start in the opening context menu.
To divide your measurement into Zones, please operate the Add button. Then, in the
table, enter the zone length as Duration. The zone tables normally only show the times,
but if you have entered a speed there and click off the Show Position in the option box,
you can also enter the position and length in meters.
If you want to delete a zone, just activate the desired zone so that it appears on a blue
background and operate the Delete option box.
Please do not forget to operate the Apply button, otherwise the changes will not become
effective.
The Command Tolerance Curve in the Index-tab Settings at the Lower Screen
Margin
Use this command to open the setup page Tolerance Curve. Here, you can define the
reference values the program will take as a basis for creating the tolerance curve shown in
the chart page facilitating the evaluation of measurements.