Meinberg SHSPZF LANTIME - Handbuch (Seite 139)

Manuelle Displayansteuerung VP100/NET
send2display Version 0.1
usage:
send2display -h hostname -s serialnumber [options]
Valid options are:
-h, --host H Uses H as the hostname of the display unit
-s, --serialnumber S Uses S as the serialnumber of the display (e.g.
03A00C7F)
-c, --clear M Clear message M (0-31)
-b, --beep Beeper sound while showing the message
-a, --clearall Clear all messages of the display
-m, --message M Create/change message M (0-31, default = 0)
-e, --executions E Sets number of consecutive executions to E (1-9, default
= 1)
-q, --quiet Quiet mode (no program output to stdout/stderr)
-v, --verbose Verbose mode (output of debugging info on stdout)
-?, --help Show help message
Defining messages
=================
a) Static or flashing text:
You can define a maximum of 9 lines for a message.
Start with -(x) "text", where (x) represents the line number.
-1, --line1 "text" Set text for line 1
-2, --line2 "text" Set text for line 2
...
You can set the duration and mode for each line separately. Specifiy the following
options directly after the text-definition of a line:
-f, --noflash Change line mode to static (default is flashing)
-d, --duration X Set the duration of the line to x seconds (default is 3
seconds)
b) Scrolling text:
You can define a maximum of 241 characters per scrolling message. If you want
the message to "softly" end, simply add some spaces to the end of your text (at-
tention: text and spaces must be no more than 241 chars in length).
-t, --scrolltext "text" Set scrolltext
139