Commissioning, operation, Shor t inf o – WIKA CPH6000 Benutzerhandbuch
Seite 41
41
WIKA operating instructions ProcessCalibrator, model CPH6000
11069023.04 11/2012 GB/D
GB
Customer-specific unit; with respect to bar
(input via numeric keypad)
Display resolution in operating mode
(back with
)
Select and confirm (standard units) via
Shor
t inf
o:
XXX
Current cursor position; alter via
◁▷ ◀▶
Parameter selection from list or menu via
0.00
Parameter input via numeric keypad
ENTER
Input confirmation
CLEAR
Clear entry
In order to switch the instrument into "MEASURING" mode, follow the instructions on
the previous page.
The following is a more detailed explanation of point "2. Preparation for
MEASURING"
a) Test item type and test item measurement signal: [----] for measurement without test
item
b) R.-Start/Range-End:
Start of measuring range and end of measuring range of the currently to calibrate test
item
c) Unit and resolution (submenu)
7. Commissioning, operation
d) Measurement uncertainty of the test item in % FS (i.e. of the span) or % rd (i.e. of the
measured value)
e) Measurement type for the test item (relative or absolute)
f) Test medium (pneumatic -> gas or hydraulic -> oil)
g) Voltage supply for test item (on/off) [If no external supply is required for the test
item, "OFF" should be selected to conserve energy]