Lenze VisiWinNet VisiWinNET Smart - Handbuch (Seite 182)

Project example
Creating a visualisation
Creating other forms and navigating between them
4
l
182 SHP−VWNS DE/EN 6.1
Creating a command button for navigating between forms
1. Use the tabs to change to the FCentral form.
2. Click the tab on top right−hand side of the Toolbox in order to show the Toolbox.
3. Under the Common Toolbox section, select the CommandButton type of control
element.
4. In the form, click the place where the control element is to be inserted.
5. Select the new control element and click on the Properties on the top right−hand
side in order to display the Properties window.
The Properties window shows the current parameters of the control element.
The type of control element chosen is used for the execution of commands. This is
defined by means of the "Command" property.
6. In the VisiWinNET properties section, mark the Command property and click on the
[...] command button there.
The dialog "Command’Editor ..."shows the available commands, listed in order in the
tab.
7. Activate the Forms tab.