Lenze VisiWinNet VisiWinNET Smart - Handbuch (Seite 229)

Configuration
Communication
Transfer project via LAN to EL1xx
5
l
229 SHP−VWNS DE/EN 6.1
5.2 Communication
The VisiWinNET
â
Smart scope of supply includes several example projects that have been
copied to your hard disk during the program installation.
These projects can be used to get to know VisiWinNET
â
Smart and, moreover, to check the
PC
«operating unit EL1xx connection and the readiness for operation of the operating
unit.
Prepare the following to control e.g. a servo inverter by means of the EL1xx and the
example project:
Drive What to do Procedure
9400 servo inverter l Make the basic configuration and select the
"Actuating drive − speed" application
l Assign CAN node address 2 (C0350)
l Transmit project to the controller
l Enable controller and activate fixed setpoint 1
^ Engineer Online Manual
5.2.1 Transfer project via LAN to EL1xx
Precondition: The network connection between the PC and EL1xx has been set up and is
active (
^ User instructions for the HMI EL1xx, chapter entitled "Setting up an Ethernet
connection"). An application running on the target device must be ended.
Proceed as follows:
1. Go into Project Explorer and open the folder Project configurationand then open the
subfolder Target device.
The "Configuration (target device)" Properties page is shown.
2. Open the Transfer tab.
3. Selection the TC/IP connection in the selection field Transfer settings.