Lenze VisiWinNet VisiWinNET Smart - Handbuch (Seite 237)

Configuration
Communication
Configure CAN connection via PDOs
5
l
237 SHP−VWNS DE/EN 6.1
7. Configure the variable as follows:
Alias: Under the alias, the variable is made available for further processing in
VisiWinNET. In this example, the name "Tx PDO 1" is chosen as the alias.
ItemID/Address: The item ID is used to establish the connection to the PDO. The
following syntax must be used for the entry: PDOxxx.Oy.
The PDO identifier is entered for xxx. The y stands for an offset in the PDO telegram, i.e.
in the event of a 0 offset, the variable will be mapped from byte "0" onwards. In respect
of this example, where the identifier has been defined with 700 and the byte variable
in byte 1 is to be mapped, the entry for the ItemID/Address must be as follows:
PDO700.O1
Data type: Definition of the data type; here "VT_UI1"
Access Rights: Specifies the type of access rights; here, "W" (Write)
The variable Tx PDO 1 can now continue being used as an item (e.g. as the "VarIn" input
field).